AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Turn Off Intel Rapid Storage4/1/2021
On platforms that have RST support built and enabled in the computers BIOS, it allows users to group and manage multiple hard disks as single volumes.This functionality is known as the Redundant Array of Independent Disks (RAID).RAID offers multiple configurations - levels - which focus on performance and redundancy.
![]() The exact terminology and steps required to access and manage RST in BIOS often depend on the specific implementation by the platform vendor. For instance, Dell computers may have different settings from Lenovo or HP computers. If you disable RST in the BIOS or change the RST configuration, Windows may become unbootable, as it may no longer be able to find and use the hard disks. It is primarily designed to utilize advanced features of hard drives connected via the Serial ATA (SATA) bus. Typically, these will be 2.5-in and 3.5-in hard disks, including both mechanical and SSD devices. The change from RST to AHCI may result in the loss of some of the advanced functionality that the RST module offers (for instance TRIM for SSD). You will need to create a side-by-side configuration for Windows and Ubuntu. In this case, the change will affect the installed Windows operating system. Likewise, if you change the controller type from RST to AHCI, Windows may no longer be able to boot. Even simply copying the important files to an external drive can minimize the risk of data loss. If the controller mode is set to anything other than Standard SATA AHCI Controller, then you will need to make a change that allows Windows to boot safely in AHCI mode. Normally, BIOS is accessed by hitting the F2 or Del key during the early boot sequence. In the BIOS menu, change the hard disk controller type to AHCI. The exact terminology and steps required to access and manage controller type in BIOS often depend on the specific implementation by the platform vendor. Windows should load normally, and you can check the controller mode in the Device Manager. For instance, this could happen if you made the BIOS change without making the registry changes in Windows. The first step is to run the disk partition tool to see and understand the disk layout. Next, you will need to display the list of volumes, make sure the volume that contains Windows is correctly assigned the letter C: (if its not, you will need to change this), make this volume active, and then run the boot repair command. ![]() It contains the files needed to start (boot) Windows, as well as recovery tools to help you diagnose and repair your system when it does not start correctly. This partition will contain the files needed to start (boot) Windows.
0 Comments
Read More
Leave a Reply. |